• Combination of the straight type and standard head causes interference when the depth of cut is head length or more. (Because holder diameter = head diameter)
  • Combination of the straight type and offset head may make the depth of cutting length or more. (Because holder diameter < head diameter)

Straight + Standard Head

Straight + Standard Head

Installation at an overhang of DC×3 or less is also possible,if the depth of cut < head length is assumed.

Straight + Offset Head

Straight + Offset Head
  • It is suitable for vertical wall machining, because the undercut type has a relief neck.
  • A taper neck with thick relief has high rigidity. Especially a stable cutting is demonstrated at deeper machining.
  • Perform straight shank additional grinding together with customer application for undercut taper neck type.
    (Refer to the cutting edge diameter (DC) of each type for the minimum machining diameter.)

Undercut + Standard Head

Undercut + Standard Head

Taper neck + Standard Head

Taper neck + Standard Head