Hone Width

If an insert with honing other than standard is needed, please order using the symbols below.

Notes on Use

Insert Installation

  • Loosen the clamp screw to install the insert.
  • Correctly mesh the insert and the holder serrations, then slide the insert to the bottom of the slot.
  • Fasten the clamp screw using the torque wrench provided while holding the insert lightly as shown. (Figure 1)
  • Check there is no gap between the bottom of the insert and holder. (Figure 2)

Tighten the clamp screw according to the torque below.

Insert Installation

Insert Replacement

  • Thouroughly clean the serrations of the holder before installing a new insert.
    Remove heavy dirt in the holder serrations by using the cleaning plate provided.