Japan
United States
Mexico
Brazil
EU
United Kingdom
Germany
Spain
France
Italy
Poland
Turkey
China
South East Asia, Oceania, South Africa
India
For steels
For stainless steels
For cast iron
For non-ferrous metal
For difficult to cut material
For hardened material
Drill Diameter Selection
When Chamfering
With respect to guide hole diameter D, select the drill diameter (cutting diameter) DC to be within the range of D < DC < 2D.
When Centering
The tool cannot be used for processing if the centering diameter has the same guide hole diameter as drill diameter DC. Refer to the usable length LU as a guideline.
In the case of tip diameter SIG 60 °, 90 °, about DC/4 which becomes a two-step point angle area does not become the bottom hole of 60 °, 90 ° respectively and chamfering is not possible.< 2D.
OPERATIONAL GUIDANCE
For finish cutting
For medium cutting
For rough cutting
