For steels
For stainless steels
For cast iron
For non-ferrous metal
For difficult to cut material
For hardened material
A sleeve for the shank of the drill to allow the cutting diameter to be increased.
Desired = (Drillø+ Increase of JFS) + .005"
(Eg.) Desired diameter is 1.015" (oversize is taken as .005").
Oversize can vary due to the cutting conditions used, please use the above as a guideline.
A sleeve for the shank of the drill to allow the cutting diameter to be increased.
Oversize can vary due to the cutting conditions used. Therefore it is recommended to purchase as a set.
When placing an order, please use the set order number. (5 sleeves/set)
It is possible to order individually. When placing an order, please use the individual order number .
Insert screws A of the side lock holder directly to the open window of the sleeve and fix the drill. Tighten screw B to a degree so as not to damage the sleeve.
The outer insert and machine X axis must be set parallel. The drill is designed that the center of the inner insert is 0-.006" lower when matching the drill center and the machine spindle center
*The inner insert may fracture if the center height of inner insert is higher than the machine X axis.
*It is not recommended to adjust to X axis minus direction (reducing direction of the hole diameter) as the holder may interfere with the hole.
For steels
For stainless steels
For cast iron
For non-ferrous metal
For difficult to cut material
For hardened material
For finish cutting
For medium cutting
For rough cutting