Aço
Aço inoxidável
Ferro fundido
Metal não ferroso
Material de difícil usinabilidade
Material endurecido
It is recommended to carry out plunging in several passes.
Following the steps above makes it difficult for chips to elongate.
This also improves the accuracy of workpiece wall surface.
It is recommended that cross-feed machining is used.
To produce high accuracy walls using MS or MM breaker insert, do not carry out back turning. Plunging is recommended.
When machining a wall, chip jamming can occur. In this case, stop cross feed machining just before the wall (at a point less than the insert width) then remove the remaining material by plunging.
When a ring remains in a cross feed end process, finish cross feed machining 1–1.5mm short of the end point, then remove the ring by plunging.
With the BM breaker insert, 3 dimensional copying is possible. Set the depth of cut (APMX) to 40% less than the insert width.
Use plunging and cross-feed machining. When machining the corner, vibration is likely to occur. To avoid this, reduce the feed by 50%.
Carry out finishing in one process.
For the depth of cut (APMX 2) when back turning, refer to the table on the right.
<Feed>
When the cutting edge approaches the centre, reduce the feed by 50%.
If necessary, stop the feed prior to reaching the centre of the workpiece to prevent it falling under its own weight.
<Spindle speed>
When using constant cutting speed during a cutting off cycle, it is recommended to limit the spindle speed to 80% of maximum to ensure stability.
To prevent the workpiece from being expelled, lower the spindle speed before finishing the grooving operation.
When there is a centre stub on solid bar work or burrs are formed on pipe material, it is possible to decrease them by using a handed insert.
With a handed insert, machining tends to be less stable when compared to using a neutral insert.
Pay special attention to avoid fracturing of the cutting edge and decrease the feed when necessary.
Fale conosco
Formulário para contatoOs cookies necessários são usados para ajudar este site a funcionar corretamente.
Por exemplo, eles fornecem a funcionalidade de retenção de login.
Os cookies analíticos coletam informações sobre seu uso deste site de forma anônima e agregada. Esses cookies são usados para analisar e melhorar a funcionalidade deste site.
Esses cookies permitem que este site forneça funcionalidade e personalização aprimoradas. Eles podem ser definidos por nós ou por terceiros.
Os cookies funcionais são usados por serviços de redes sociais para rastrear o uso de seus recursos integrados. Por exemplo, esses cookies permitem que você compartilhe páginas deste site com sua rede social.
Os cookies de publicidade podem ser definidos através deste site por nossos parceiros de publicidade com base nos dados obtidos. Eles identificam seu navegador e dispositivo de internet exclusivos e podem ser usados para fornecer dados demográficos anônimos, criar perfis de seus interesses e exibir publicidade relevante a esses interesses.
Aço
Aço inoxidável
Ferro fundido
Metal não ferroso
Material de difícil usinabilidade
Material endurecido
Acabamento
Usinagem média
Desbaste