For steels
For stainless steels
For cast iron
For non-ferrous metal
For difficult to cut material
For hardened material
The width of the wiper insert itself is 5.5mm, however the actual functioning cutting edge width after installation to the body is 4.5mm, as shown in the diagram.
With one wiper insert, it is possible to machine up to fr=4mm feed per revolution. When exceeding fr=4mm, use two or more wiper inserts. Note that there is a possibility to exceed fr=4mm when using a holder with more than 24 inserts.
Technical consultation from here
24/7Contact formNecessary cookies are used to help this website function properly.
For example, they provide login retention functionality.
Analytical cookies collect information about your use of this website in an anonymous and aggregated form. These cookies are used to analyze and improve the functionality of this website.
These cookies enable this website to provide enhanced functionality and personalisation. They may be set by us or by third party providers.
Functional cookies are used by social networking services to track the use of their built-in features. For example, these cookies allow you to share pages from this website with your social network.
Advertising cookies may be set through this website by our advertising partners based on the data obtained. They identify your unique browser and Internet device and may be used to provide anonymized demographic data, build profiles of your interests, and display advertising relevant to those interests.
For steels
For stainless steels
For cast iron
For non-ferrous metal
For difficult to cut material
For hardened material
For finish cutting
For medium cutting
For rough cutting